We offer various training courses for operators, programmers and maintenance staff. Use the expert knowledge of our training managers to enhance and deepen your own know-how. Please note that, depending on the type of training, training is either held in our training centre in Jena (recommended) or directly on your site. The seminars take place in small groups to guarantee a high quality learning experience.
Additionally we offer individual remote training sessions via your internet connection.
Remote training session
Do you have questions about test program generation and optimization? Would you like to extend your knowledge in special test functions?
We are pleased to offer you an online training session tailored to your individual needs.
- AOI seminars for beginners (basics) PILOT 5.3
- AOI seminars for beginners (basics) PILOT 6
- AXI seminars for beginners (basics) PILOT 4.x
- SPI seminars for beginners (basics) PILOT 6
Seminar on AXI machine and programming software
Seminar on operating the AXI machine software PILOT Inspect
This seminar is aimed at AXI operators and programmers. In this half-day seminar, the machine software PILOT Inspect 3.3 is taught on an X-ray system of the X-Line series. The seminar starts with an introduction to the software interface, followed by a discussion on all available AXI system apps (e.g. inspection, inspection history, machine status, calibration).
Seminar on upgrading the AXI Machine Software to Version 3.3
This seminar is aimed at AXI system operators. The 2-hours Seminar will focus on user interface changes as seen when upgrading to PILOT Inspect version.
Seminar on upgrading the AXI programming software to version 3.3
This seminar is aimed at the programming personnel. This 2-day seminar teaches the changes from Version 3.2.2 to 3.3 of the programming software PILOT AXI – XI Programm Editor.