SCANBOOSTER/PCI, SCANBOOSTER/USB and SCANBOOSTER/USB-FXT for JTAG/Boundary Scan test - GOEPEL electronics

The SCANBOOSTER/USB is equipped with a USB 2.0 interface and provides two separate and independent TAPs. It supports a programmable TCK frequency up to 16 MHz.

By utilizing GOEPEL electronic’s TIC01 (TAP Interface Card) modules serving as interface between controller and UUT, some of the SCANFLEX^® advantages apply. That means both TAPs are independently programmable with regard to output voltage, input voltage, output impedance and input impedance.

Using GOEPEL electronic’s CION™ ASICs as driver circuit, the TAP have outstanding good signal integrity in combination with special features for interface protection. The controller offers additional resources such as 32 bit Parallel I/O (dynamic), two analogue I/O, three generic digital I/O as well as three trigger signals.

The SCANBOOSTER/USB-FXT is equipped with a USB 2.0 interface and provides two fully independent TAPs. It supports a programmable TCK frequency up to 16 MHz. Both TAPs use externally controlled active test heads (exclusively). The distance between the controller and TAP head can be up to 4m/12ft without loss of performance.

Exteneral TAP heads such as TIC02/03 offer programmable input and output voltage and isolation relays. For applications where difficult access problems are encountered for instance thermal and vibration testing, the TIC03 is available with extended temperature range. It was particularly developed for HASS/HALT applications.

The SCANBOOSTER/PCI is a plug-in card for 32 Bit PCI bus with 33 MHz bus cycle. The controller provides two separate TAPs and supports a programmable TCK frequency of maximal 16 MHz.

Both TAPs are independently programmable with regard to output voltage, input voltage, output impedance and input impedance. By utilizing GÖPEL electronic’s CION™ ASICs as driver circuit, the TAP have outstanding good signal integrity in combination with special features for interface protection.

The controller offers additional resources such as dynamic 32 Bit Parallel I/O, trigger signals, an SCP bus for system extensions and a specific interface for parallel gang testing of up to eight UUT.

The SCANBOOSTER/PCI-DT consists of a PCI plug-in card coupled with an external controller unit, whereby distances can be up to four meters. It provides two fully independent TAPs and supports a programmable TCK frequency up to 16 MHz.

Both TAPs use externally controlled active test heads (exclusively). By utilizing GOEPEL electronic’s TIC01 (TAP Interface Card) modules serving as interface between controller and UUT, some of the SCANFLEX® advantages apply. That means both TAPs are independently programmable with regard to output voltage, input voltage, output impedance and input impedance.

The SCANBOOSTER/PCIe-DT consists of a PCI Express plug-in card coupled with an external controller unit, whereby distances can be up to four meters. It provides two fully independent TAPs and supports a programmable TCK frequency up to 16 MHz.

Both TAPs use externally controlled active test heads (exclusively). By utilizing GOEPEL electronic’s TIC01 (TAP Interface Card) modules serving as interface between controller and UUT, some of the SCANFLEX® advantages apply. That means both TAPs are independently programmable with regard to output voltage, input voltage, output impedance and input impedance.

The SCANBOOSTER/PEC is equipped with a Cabled PCI Express x1 interface. The controller provides two fully independent TAPs and supports a programmable TCK frequency up to 16 MHz.

Both TAPs use externally controlled active test heads (exclusively). By utilizing GOEPEL electronic’s TIC01 (TAP Interface Card) modules serving as interface between controller and UUT, some of the SCANFLEX® advantages apply. That means both TAPs are independently programmable with regard to output voltage, input voltage, output impedance and input impedance.