IEEE 1149.1 Training Accessories
The introduction of new technologies such as Boundary Scan always requires the gain of necessary knowledge in theory and practice. In addition to the respective [seminars], GÖPEL electronic also provides demonstration boards and kits for autodidactic practical training.
VarioTAP Coach-ARM
VarioTAP Coach is suitable for both beginners and advanced users in industry, research and education. It was developed as an evaluation kit for the demonstration of merged Boundary Scan applications and JTAG emulation tests. The board provides several interfaces like CAN, USB, RS232, I2C, parallel digital I/O and Audio. Furthermore, it enables the practical trial of a multitude of different JTAG/Boundary Scan applications.
- Flash programming via JTAG emulation or via Boundary Scan
- Programming of PLD
- Execution of Boundary Scan test operations, dynamic emulation tests for memories, bus devices, and peripheral interfaces
In addition to the demonstration of the functional principle of the VarioTAP IP, the application of VarioCORE IP for the flexible debug and test instrumentation on the basis of dynamic FPGA reconfiguration can be evaluated.
| ||
| The Scan Coach board has been designed especially for beginners and shows how to overcome typical traps during JTAG/Boundary Scan test and programming development. It features following components, 2 JTAG/Boundary Scan devices, FLASH, SDRAM, buffers, simple logic as well as edge connectors, LEDs, a 7 segment display and failure switches. | |
Scan Coach Kit/USB
The Scan Coach Kit/USB is a complete solution to get in-depth knowledge of the JTAG/Boundary Scan technique. It consists of a special version of [CASCON GALAXY®], a SCANBOOSTER/USB as JTAG/Boundary Scan controller and the Scan Coach board.
A tutorial is available, describing in detail how to develop different JTAG/Boundary Scan test programs and how to overcome typical problems. Besides, it provides an introduction into the GOEPEL electronic’s JTAG/Boundary Scan test system and information for both JTAG/Boundary Scan circuit design and different programming techniques.
All required components, such as software, JTAG/Boundary Scan controller, Scan Coach board, test bus cable, example programs and descriptions are supplied with the kit. Only a PC with parallel interface is required. The SCANBOOSTER/USB is connected to the UUT by a 10pin flat cable which powers the Scan Coach board.
| ||
|
| |
VarioTAP Coach-ARM Kit/USB
The VarioTAP Coach-ARM Kit/USB is a complete solution to get in-depth knowledge of the JTAG/Boundary Scan technique. It consists of a special version of [CASCON GALAXY®], a SCANBOOSTER/USB as JTAG/Boundary Scan controller and the VarioTAP Coach-ARM board.
A tutorial is available, describing in detail how to develop different JTAG/Boundary Scan test programs and how to overcome typical problems. Besides, it provides an introduction into the GOEPEL electronic’s JTAG/Boundary Scan test system and information for both JTAG/Boundary Scan circuit design and different programming techniques.
All required components, such as software, JTAG/Boundary Scan controller, VarioTAP Coach-ARM board, test bus cable, example programs and descriptions are supplied with the kit. Only a PC with parallel interface is required. The SCANBOOSTER/USB is connected to the UUT by a 10pin flat cable which powers the VarioTAP Coach-ARM board.
| ||
|
| |
